diff options
Diffstat (limited to '')
| -rw-r--r-- | README.rst | 30 |
1 files changed, 13 insertions, 17 deletions
diff --git a/README.rst b/README.rst index fcf828528d..6e3ee01f2e 100644 --- a/README.rst +++ b/README.rst @@ -220,6 +220,11 @@ is configured to use TLS for `Federation`_ with a self-signed or verified certificate, but please be aware that a valid certificate will be required in Synapse v1.0. +If you would like to use your own certificates, you can do so by changing +``tls_certificate_path`` and ``tls_private_key_path`` in ``homeserver.yaml``; +alternatively, you can use a reverse-proxy. Apart from port 8448 using TLS, +both ports are the same in the default configuration. + ACME setup ---------- @@ -261,13 +266,12 @@ Make sure to restart/reload your webserver after making changes. **Authbind** -``authbind`` allows a program which does not not run as root to -bind to low-numbered ports in a controlled way. The setup is simpler, but -requires a webserver not to already be running on port 80. **This includes -every time Synapse renews a certificate**, which may be cumbersome if you -usually run a web server on port 80. Nevertheless, if you're sure port 80 is -not being used for any other purpose then all that is necessary is the -following: +``authbind`` allows a program which does not run as root to bind to +low-numbered ports in a controlled way. The setup is simpler, but requires a +webserver not to already be running on port 80. **This includes every time +Synapse renews a certificate**, which may be cumbersome if you usually run a +web server on port 80. Nevertheless, if you're sure port 80 is not being used +for any other purpose then all that is necessary is the following: Install ``authbind``. For example, on Debian/Ubuntu:: @@ -282,12 +286,6 @@ When Synapse is started, use the following syntax:: authbind --deep <synapse start command> -If you would like to use your own certificates, you can do so by -changing ``tls_certificate_path`` and ``tls_private_key_path`` in -``homeserver.yaml``; alternatively, you can use a reverse-proxy, but be sure -to read `Using a reverse proxy with Synapse`_ when doing so. Apart from port -8448 using TLS, both ports are the same in the default configuration. - Finally, once Synapse's is able to listen on port 80 for ACME challenge requests, it must be told to perform ACME provisioning by setting ``enabled`` to true under the ``acme`` section in ``homeserver.yaml``:: @@ -725,10 +723,8 @@ port. Indeed, clients will use port 443 by default, whereas servers default to port 8448. Where these are different, we refer to the 'client port' and the 'federation port'. -The recommended setup is therefore to configure your reverse-proxy on port -443 to port 8008 of synapse for client connections, and port 8448 for -server-server connections. All Matrix endpoints begin with ``/_matrix``, so an -example nginx configuration might look like:: +All Matrix endpoints begin with ``/_matrix``, so an example nginx +configuration for forwarding client connections to Synapse might look like:: server { listen 443 ssl; |